When restoring a flat roof, it is essential to have flat warm roof insulation installed for better energy efficiency.If it feels like the time has come to replace your flat roof, you might just need a little bit of attention and not a full replacement. Roof replacement and roof restoration are quite different. Here are a few things you need to understand about why you should restore your roof.
Saves You Money and Time
Replacing a roof is typically a long and expensive process. First, you need to pay for the removal of the old roof. Then you need to pay for the removal of the old roofing waste. Lastly, you need to pay to have the new roof put on and all of the other costs that come along with it. When a roof is being restored the old roof is left intact. This process includes cleaning and repairs that make it look good again and ensure that it lasts longer.
Not only does this cost less, but it also takes less time than performing an entire roof replacement. Depending on the shape of the roof, a roofing contractor could finish the job within a day which brings down the cost even further. The more time a contractor spends on your roof, the more it’ll cost you.
Improved Energy Efficiency
When you choose to restore your old roof, it can make your home more energy-efficient. Modern technology has found that cool roof coatings are able to improve the efficiency of your house and your roof. This can save you money immediately.
Older roofs tend to leak and which makes your heating system work harder to keep things warm when it’s cold and cool when it’s hot out. When you choose to restore your roof and are looking for a roof repair quote, a roofing professional will come and inspect the entire roof thoroughly. They will find all of the leaks you might have and will then repair them to get your roof operating at maximum efficiency.
Increased Life Expectancy
All roofs need replacing eventually. at some point. Its lifespan is mostly influenced by the roofing material used to construct it and the climate it’s exposed to. When you restore your roof you can add up to 10 years onto the life of your existing roof. If your roof is nearing the end of its existence but is still in good nick, then it’s a good time to be proactive and to look into doing a restoration.
What to Expect During a Roof Restoration
The depth and amount of restoration needed for the roof depend on the current condition of the roof. It also depends on the materials used during the initial construction. Most restorations involve a four-step process – inspection, cleaning, the repairs and the coating.
1. Inspection
Your roofing contractor will make a complete and thorough inspection of the roof. During the inspection, they will check the inside and the outside and the frame for any weakness. Bad weather, poor quality installation, and fallen branches are among some of the most common causes of roof damage. A contractor will do this and take note of any areas of damage that need repairing during the restoration. They then check for leaks and water damage. They pay special care and attention to the edges and the peaks of the roof as these areas are quite vulnerable to damage.
After their initial inspection is complete, the contractor will give you their recommendation of whether restoration is right for you and your roof. They will then give you an estimated cost for the job. This typically takes place within an hour.
2. Cleaning
Once you agree to the terms of the restoration, your contractor will start the process by giving your roof a thorough clean. This is done with a high-pressure washer and, depending on the size of your roof, will take a few hours.
The cleaning’s purpose is two-fold. Firstly, it gets rid of the years of dirt, mold, and grime build-up on the surface. You also get a bonus gutter cleaning when they do this. It is easier to spot damage on a clean roof, so the contractor takes note of any additional spots that need attention that could have otherwise not been seen before.
Secondly, when water is used to clean the roof, the water doubles as a way to check for leaks. The inside of the roof is checked after cleaning to see if water has made its way inside.
3. Repairs
After it has been cleaned, repairs can begin. This can take up to a day.
4. Coating
This step is key to protecting your roof. It protects against water damage, rust and insulates your roof. The type of coating depends on the roofing material used.
Restoration is a great way to go. It saves you time, money and is a more environmentally friendly option.